Sadly I worked the entire winter holidays so nothing got done on the bike till today. Today I put the newly polished tappet covers on and the new 19 tooth gearbox sprocket. Old one was 23 tooth. Highway speeds at 2500rpm's. The new one will give me some much needed acceleration between gears.
Tommorow, depending on classwork load, I will get the belt drive on with its fancy new double ended adjuster.
Fitting the belt drive has been more troubling. The clutch hub is scraping against the inside of the inner chaincase cover. It will have a date with my grinstone some time in the near future.
I have to start writing my thesis this weekend so it looks like the bike is going to have to collect dust for a little while. Next project is getting the belt drive to fit right. Then gearbox adjuster, oil tank and then battery box.
I got the wheels back. Nicely laced and trued by Cyclops cycles in Shawnee Kansas. They did a fantastic job and did it in just 2 days. The gears in the gearbox were shot. I ended up replacing all of them, I also bought a gearbox rebuild kit so it is effectively a brand new gearbox now. Strangely enough, after I put it all together, it worked. No one was more surprised than me. Building gearboxes will humble you. The disk brake looks lovely when you get up close too. I have the engine back, hopefully I will have time to reassemble it and put it back into the frame in the next couple weeks. The new belt drive kit is sitting on my kitchen table and will go on shortly afterwards.
Got the wheel hubs back from Colorado Norton Works today. They look fantastic! I have always prided myself on being fairly good at polishing metal, having done it since I was a little kid, but I have met my match with Colorado Norton Works. Considering the condition of what I sent them, the result was better than I had hoped for. The hubs have the new sealed bearings in them and overall they look great. They also supplied me with new alloy fork seal retainer nuts which weigh exactly nothing and look sharp. Website at http://www.coloradonortonworks.com/
Against my better judgment I decided to polish up the gear box casing like the rest of the bike. It did not turn out as nice as I had hoped. There were too many places that I could not get to with my bare hands and the drain plug area looks awful. I console myself in the fact that the easily visible areas look good. Oh well, i'll get to properly over the winter.
I decided against my better judgment to overhaul the gearbox. I know nothing about gearboxes. We will see how this works out. I got the gearbox overhaul kit from RGM with the fancy new bearing and oil seals. The below pics are after its all pulled apart. Wish me luck getting it all back together.
Some before and after photos of the fork slider I found on ebay. The before photo's are taken AFTER 8 hours of wet sanding. What a glorious weekend that was. I took the before photos and then put it striaght on the buffer. Rough soap, fine soap, then Autosol polish on the buffing cloth. Autosol is undoubtedly the best polish on earth. It smells really good too.